YakGear StandNCast Bar

$194.99

Out of stock

Description

The YakGear StandNCast is a great addition for your kayak, canoe or skiff to assist you while standing and casting for your favorite catch. Constructed out of anodized aluminum, the StandNCast will fit any kayak or canoe with a top width of 22 inches to 37 inches and can be deck mounted or track mounted. Keeping in mind of where to store your paddle while standing, the StandNCast includes two paddle holders across the top leaning area.  As always, this complete kit comes with all stainless steel installation hardware, installation instructions, and rigging tips from YakGear.  Waterproof silicone recommended but not included.

Adding accessories is easy using the Railblaza RailMount 32-41 as your base of choice and then adding an additional rod holder, cup holder or push pole holder.  Railblaza RailMount 32-41 and additional accessories are not included.  Installation instructions and hardware are included.

  • Constructed out of anodized aluminum
  • Includes two paddle holders
  • Add accessories easily using the RAILBLAZA RailMount 32-41
  • Railblaza RailMount 32-41 and additional accessories not included
  • Installation instructions and hardware included
  • Some assembly required

Additional information

Weight 4.5 lbs

Reviews

  1. This thing is killer. Super easy to install, lightweight and durable. I put it to the test and leaned against it an unreasonable amount, and it didn’t budge. Makes standing up and fishing a lot easier, as you no longer have to lean over to set your paddle down, which inevitably clanks against your boat and spooks the fish. You can also mount Railblaza Starports on the rails for rod holders, camera booms, etc. Very slick setup that I believe fits just about any fishing yak out there.

  2. The StandNCast is an excellent addition to any fishing kayak. Well made, easy to install works well. Mine arrived later than promised. Although it was listed as "In stock" there was a component unavailable that delayed its shipment. When it arrived, one factory installed end cap was on the wrong end of one of the 30" bars. It was easy enough to fix but should have been caught by quality control prior to shipment.

Add a review

Your email address will not be published.

« SHOP | MENU »
preloader